#
# GNSS receiver configuration
#

menuconfig GNSS
	tristate "GNSS receiver support"
	---help---
	  Say Y here if you have a GNSS receiver (e.g. a GPS receiver).

	  To compile this driver as a module, choose M here: the module will
	  be called gnss.

if GNSS

config GNSS_SERIAL
	tristate

config GNSS_SIRF_SERIAL
	tristate "SiRFstar GNSS receiver support"
	depends on SERIAL_DEV_BUS
	---help---
	  Say Y here if you have a SiRFstar-based GNSS receiver which uses a
	  serial interface.

	  To compile this driver as a module, choose M here: the module will
	  be called gnss-sirf.

	  If unsure, say N.

config GNSS_UBX_SERIAL
	tristate "u-blox GNSS receiver support"
	depends on SERIAL_DEV_BUS
	select GNSS_SERIAL
	---help---
	  Say Y here if you have a u-blox GNSS receiver which uses a serial
	  interface.

	  To compile this driver as a module, choose M here: the module will
	  be called gnss-ubx.

	  If unsure, say N.

config GNSS_W2SG0004
	tristate "W2SG00x4 power on/off driver"
	depends on GPIOLIB && SERIAL_DEV_BUS
	help
	  Enable on/off control of W2SG00x4 GPS module connected
	  to some SoC UART to allow powering up/down if the /dev/gnss
	  is opened/closed.

	  It also provides a "rfkill gps" name to control the LNA power.

config W2SG0004_DEBUG
	bool "W2SG0004 on/off debugging"
	depends on GNSS_W2SG0004
	help
	  Enable driver debugging mode of W2SG0004 GPS. If you say y here
	  this will turn on the W2SG0004 module and you can check if it is
	  correctly turned off by the driver by inspecting the system log.


endif # GNSS
